![]() And, of course, I see some who are mixing up a their plaster from scratch (e.g. I read an OHW article saying newer pre-mixed joint compounds have limited shrinkage and the suggestion on minor cracks was to simply tape and feather out joint compound (just like I would finish drywall). ![]() I also understand that a some cracks need to be cut out some to make room for the new plaster and get out loose plaster out, etc.īut then I see articles or posts suggesting the application of bonding agents, using tape, or using regular joint compound from the bucket. I think this is the product I would use in my case given the type and extend of cracks (but that is the essence of my question). Then, I would use something like Easy Sand since that is sandable (versus something like Durabond). In my case, I don't think that is needed. If I had an area that was down to the lath, using a product like STRUCTO-LITE would make sense. After skimming (no pun intended!) many forums and posts, I think I would take the following actions. But I am just frustrated not knowing exactly what products to use on the plaster so that I don't screw up. I've done some drywall work in the past (hanging, finishing, etc) and I am comfortable with light construction. there is a chunk of plaster chipped off). But we also have a few areas with cracks and some areas where outside edges needs correcting (e.g. But I think we are just seeing remaining glue and some minor plaster repair needs. At first I was worried that the plaster never had the final skim coat. When I run my hand over the wall it certainly has some somewhat rough areas. I think we still have a bit of glue on the wall. From what I can assess, the walls are in decent shape. ![]() Knowing that this new forum has some good people, I wanted to reach out for general opinions.įirst, we just took down the wallpaper in our foyer, stairway, and 2nd floor hallway and we plan to paint. I find that many times the articles cover the basics but don't get down to specifics on what products are used. :/ I have tried over the last few days to read through every article I can find on plaster repair. casien and calcimine paints), and silicone.I feel like I am going to get dinged for asking yet another plaster question. Weld-Crete® is also used for: bonding setting beds for ceramic tile bonding Portland cement plaster and stucco mixes and to bond to surfaces such as brick, block, tile, marble, metal, glass block, soundly adhered paint (non-soluable in water, i.e. Use Weld-Crete’s® open time to your advantage in bonding to concrete shear walls when you need a time lapse between application of bonding agent, placement of reinforcement steel, placement of formwork and placement of concrete. Weld-Crete® can be “painted on” in a single application 1 hour to 10 days prior to concrete placement. For exterior and interior use, Weld-Crete® will bond new concrete, Portland cement plaster and cementitious mixes to structurally sound concrete floors, walls, columns, beams, steps and ramps. The original chemical concrete bonding agent, Weld-Crete® incorporates polyvinyl acetate homopolymer in a patented formulation. Weld-Crete® bonds new concrete, stucco, tile setting beds and terrazzo to any structurally sound surface, interior or exterior. Vinyl and Copper Flashing/Control Joint.Detectable Warning Systems – Alert Panels.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |